ElectrIQ AIRFLEX 15 User Manual download pdf (Page 6)

Page 6 of 17

Assemble hose fish tail adaptor: Prepare both parts

of hose adaptor and clip them together. Do not push too

hard as this may cause damage. Extend one head of

the hose and screw the adaptor to it.

Note: to screw it into place should take no less than

three rotations

Installation of window kit

Partially open the window and then fix the window kit to the window horizontally or vertically.

Keep at least 50 cm from any objects and the air inlets grills on the side of the unit.

Clip the other end of the hose with the fishtail adapter to the air outlet of the window slider.

Make sure the unit is upright and there are no obstructions to the air inlets and outlet grills.

The window kit is only designed to be installed with sliding or sash windows or doors. The

window kit is not made to be used with any other style of windows. However the fish tail

adaptor can be used with most windows / doors but there will be a cold air escape making

unit less efficient. When using the cooling mode ensure that the opening left is as small as

possible. The best form of installation is through a wall duct.

Please note that the unit will need to be vented out in heating mode, ideally through the wall.

By properly venting your air conditioner expels cold air from your room while efficiently

heating it without leaving cold air coming back.

Note: Avoid bending the air hose more than 30 degrees!

Important safeguards

The length of the soft hose extends from 28 cm to 150 cm. If hose is extended above this

length the unit may malfunction and this can invalidate the warranty. Shorter the hose the

better the results; ideally do not extend more than 40 cm. The outlet vent must be well

ventilated and not obstructed as this will cause the unit to overheat.

1 2 3 4 5 6 7 8 9 10 11 ... 16 17

No comments

ElectrIQ AIRFLEX 15 User Manual Page 6